Seal it Right 168 – Color: Clear | White | Black

Roll over image to zoom in
Click to open expanded view

In stock

HANDLING AND SAFETY

  • Wear eye protection when handling uncured sealant as it can irritate eyes. In case of

eye contact, immediately flush eyes well with water and contact a physician.

  • This product releases methyl ethyl ketoxime vapors as a by-product of cure. Adequate

ventilation must be maintained in the work place at all times.

  •  Extended contact with the skin may cause irritation and should be avoided.
  •  Not for food contact use.

STORAGE

  • Store in a cool, dry, dark place
  •  Keep out of reach of children.

PACKAGING

  • 300 gram e cartridge available in carton box of 24 pieces

COLORS

  • Available in 4 colors

Clear (C) White(W) Black(B)

Category:

KEY PERFORMANCE PROPERTIES

  • One component, ready-to-use sealant
  • Room temperature cure
  • Neutral cure (ketoxime cure)
  • Easy gunnability over a wide temperature range
  • Maintains good flexibility
  • Excellent adhesion to many materials

APPLICATIONS

  • Sealant for glass-to-glass and glass-to-metal sashing
  • Sealant for pre-fabricated housing, freight containers, cold storage rooms interior

sealing in building and housing

TYPICAL UNCURED PROPERTIES

   

SEAL IT RIGHT-168
Consistency Paste
Specific Gravity                                (23°C) 1.03
Extrudability                                        sec                   3
Tack-Free Time                                (23˚C) min 15
Slump                                                   mm <1

TYPICAL CURED PROPERTIES

   

SEAL IT RIGHT-168
Hardness 25
Tensile strength                               MPa 1.2
Elongation                                            % 300
Adhesion area 100% cohesion failure
UV resistance Excellent

Test Method: JIS A 1439
Typical property data values should be used as specifications. Assistance and specifications are available
by contacting Momentive Performance Materials.

APPLICATION INSTRUCTIONS

  • SURFACE PREPARATION

Substrate surface should be thoroughly cleaned with a suitable solvent such as
alcohol, xylene, or methyl ethyle ketone (MEK). Do not use soap, detergent or water.
Wipe the surface dry. Sealant will not properly adhere to a wet substrate.

  •  MASKING

To obtain a neat sealant line, use masking tape to cover areas adjacent to any joints
before priming.

  • PRIMER

A preliminary adhesion test of sealant on the substrate is recommended to ascertain
proper adhesion. For difficult-to-bond substrates, use of a primer (TOSPRIME C,D or
E) is suggested. Please refer to the chart on page 3 for proper primer selection. Allow
primer to dry thoroughly before proceeding.

  • BACK-UP MATERIAL

Do not apply sealant in direct contact with organic rubber such as chloroprene or EPT
etc. Rubber closed to into back-up materials may stain the silicone sealant.

  • APPLYING AND TOOLING SEALANT

Cut nozzle to desired bead size, break the membrane film completely and extrude
sealant in the joint. Tool immediately, within 5 minutes of application, with a spatula to
spread the sealant against the back-up material and joint surfaces. Remove masking
tape immediately after tooling. Sealant will begin to skin on the exposed surface in
about 10 minutes and cure will progress inward.

Related products

K-Supply Co., Ltd